Viewing all customer Discussions for:

Door & Window

I need help identifying this window crank.

Hello...I am looking for the post that is located in the top and botton of the storm door...it secures the door on the top frame and lower door frame...it is a round shape with a locking screw and will slide up and down (vertically) in the edge of the door...do you know what that is called and do yo ... (cont.)

Bottom pivot on commercial door. the door is about 20yrs

No markings that I could see. Thank you!

This is a plastic piece that attaches to the top end of the sliding glass doors. The first picture is a piece on the door, the second two pictures are a broken piece removed.We also need some of the weatherstripping that runs along the top of the door behind the corners of this piece. ... (cont.)

Hi. This is stamped 27 C (b.s.i.?), i think its on one of the pics. I cant get to any still installed for a pic at the moment..most are broken. Is this enough for identification purposes? Thanks!

Hello,I have had trouble in locating parts for some vinyl casement windows. I have found the operators and handles, I now need to locate another part. Thank you,VinnieNRJ Home Improvement Service, Inc.

I ordered part #182-239 : Multi-Point Mortise Lock and Keeper, 9-7/8" (SWISCO.com order #114061) for my back sliding glass door lock mechanism. Unfortunately the keeper is not long enough to match the mounting holes on my door, and I can not use the lock with my current keeper, as the screw holes w ... (cont.)

Hi, I have a slider that has a double hook latch system. The latches stick shut from time to time. I want to replace the latch lock assembly, but if I need to replace the hole handle and locking assembly I ok with that. The door was installed in July 2008 during a remodel and it was brand new. I bel ... (cont.)

Hello If you can tell me which part I have. I have gone over all the guides on your website but I cannot make a match with the measurements I have. Thank you

There is one on each window corner. Probably needed to grab/hold the balance when closing down the window. I took this out of a customers window and didn't think to take a picture of it attached to the window.

I tried searching on your site for this part. Do you carry these, and what would it be called? I finally figured out what Operators will work, now I'm down to this piece. I'm so glad you had operators that will work for me, I just hope I can get everything I need in one shot. Thanks in advance. ... (cont.)

The plastic gear mechanism inside the interior door handle that rotates the locking arms has broken and cannot be repaired. Exterior door handle and lock are fine. I need an interior replacement part that will accept the lock stir into it. My door handle measurements are the same as your product ... (cont.)

I am looking to replace a broken patio door handle. The broken part is the lower part shown in the photographs. The spigot that holds the screw in place has broken. It looks like your 82-080 mortice handle, however, the fasteners on my door handle are on the plate that the handle fastens too, not th ... (cont.)

Looking for a Swisco balancer to replace the one in picture attached. Also need top sash part also shown in the picture. 1 balancer has part #2930, shown in picture. A second balancer has a part number if #3620 which is a different sized Alcan window. Please advise if more information is needed. ... (cont.)

The spiral mechanism I removed is enclosed in a white plastic tube. The tube length is 25 inches and the width is 3/8 inch. The plastic tip is a white color, but the color choice for a S900-25 is either red or blue, no white is offered. The weight of the window sash is 17.9 pounds. Which color ti ... (cont.)

I need several of these coils. I am showing the two sections, top and bottom. The top is located at the top of the bottom sash, the bottom is a traditional piece common to vinyl windows.

Hello, We have put together a hardware order but have one part that we can not seem to identify. Please see photos of drum roller attached that we need to ID. We would be looking to order Thirty (30) of these. These would be used with Swisco series 152 coil balances for 9 lb. sash. ... (cont.)

There are two parts here. The Pivot Lock Shoe and a piece which attaches to the holes on front of the pivot shoe lock to add depth and width. I'm pretty the pivot shoe is https://www.swisco.com/Pivot-Shoe-5_8-inch-Thick/pd/Tilt-Window-Replacement-Pivot-Lock-Shoes/15-047 but I cannot find any informa ... (cont.)

I have a windows that don't stay open. It has spiral ring inside the cylinder and need for couple of windows