Viewing all customer Discussions for:

90-005 Window Sash Lock, 2-1/4"

Pennco window lock is 2 3/4 inches long and 3/4 inches wide.

Good Morning, I am trying to replace broken hardware for glass block tilt windows in my house. I am looking for the correct part numbers for both the latch and the keeper. The distance between hole centers is 2 1/4 inch on the latch and 1 1/4 inch on the keeper. Please find attached photos of ... (cont.)

Good afternoon, I spoke with someone last week about my window troubles and looking for some help. Haven't been able to open the window for years and it's time to fix it. I'm very handy around the house and will fix them myself if able. Thanks in advance

Window balances - I just spoke to someone about getting replacement ones for my window that is 461/4 x 58 1/2 I have some photos but the old balances are not in the window - I did take a picture of the one in my bathroom (which is very small not the same size) I am hoping you can assist me in fi ... (cont.)

Part No.#8244 is stamped onto the underside of my broken Sash Lock. My Harvey Windows were installed when my house was newly built in 1999. As the sash lock sits on the top of the lower inside window, its width = 2 7/8", by 3/4" deep. The (2) holes on this Sash Lock are 2 1/4" apart; measuring from ... (cont.)

I need to replace the swing latch that's broken on a couple windows. The photos are of a non-broken one. Also, the knob that slides the bottom lock up and down has broken off. Your form won't allow me to add more photos of this part. Do you have these parts? Thanks so much! -Marla ... (cont.)

Window locks

The latch is broken and I am unable to find one. This latch is on block windows in basement and is on under side

Need replacement

I need a latch that looks like your 90-005 only the opposite hand.

I could use some part numbers for these parts. Only the right locking latch is broken but for spare parts I could use right and left locking latch and left and right tilt latches. Thanks.

On Swisco's website, you sell Product Code 90-005 (window sash lock, 2-1/4"). However, when I measured the defective window sash lock, I measured 2-3/4". Am I measuring wrong? Is Product Code 90-005 the correct replacement for my broken window sash lock? I'm confused - maybe I should just be mea ... (cont.)

Please provide the part number for this window balance. If I were to only replace the channel balance top what is the part number? Mine has a rivet.Paul

See attached photos of our bathroom window and the latch. We can't open the window because the slider part has broken off.

Looking for a half dozen of these latches. No markings on them. They are 2 1/4" from center of the drill hole to hole. Approximately 3/4" wide and 2 3/4" long. Used with a Croft upward sliding window approximately 6 years ago.

I am trying to find replacement parts for my double paned casement windows. The name on the windows is ," The Insulator ". I can't find this company anywhere.

We are working on a project with approximately 20 year windows. We need to source some parts.

Hey Window gurus I need to identify the two pieces pictured. I need four of the latches and one of the pivots. Please let me know what other info is needed to identify the right parts. Thanks in advance

I have a broken lock which need replacing. The window manufacturer is out of business, Milestone.

This is my home window and I need both of the little locks.