Viewing all customer Discussions for:

S380-21 21" Series 380 Channel Balance

Hello! I need to replace my 21" channel balancers for a single hung non tilt window. I look forward to hearing back from you. Jen

Hello, I'm looking to replace the channel balances in a Viking window I have. Looks like the part number is 2040 FD. It looks like the metal part is 21" long. If you measure the whole piece, including the plastic parts on the ends, it is 22-1/16" long. Let me know if you have the part. I would ... (cont.)

I am looking for two replacement balances. Stamp is 20CUSB. Photos are attached. I live in Canada, where can I purchase these?

need balances.

Need two sash balances and two 1.25 x .25 metal stoppers. There is a 20C stamped on the channels.

20 4 KP CALDWELL

I need to replace the balancers on my Milgard Vinyl window. The window is approximately 20 years old. sash weighs approximately 16 lbs, channel is 1/2" in width metal part of balancer is 21" long There is also a little plastic part that's 5/8" x 1/2". ( please see all pictures attached). Pleas ... (cont.)

Length 20 7/8" channel. the left balance is stamped 20 4 CQ caldwell. The right balance is stamped 20 3 JR caldwell. It is a Milgard window, unknown date of mfg. I'll need two balances. Feel free to email me if you need further information. Thank you, lee

I need to replace older window balances for a smaller vinyl window. Please confirm in the photos but I think the part number is 20-3 ED5 CMC 68. Can you help me find the correct part?

21 inches. 2040 stamped on it. I will need 6 balances.

21 inches long 1/2 inch channel Please see images Please provide window channel balance info and fittings specifications

The numbers on the window channel balance is "20-2 DA2 CMC 7" The metal channel is 21" long X 9/16" Wide X 5/8" Deep. Can you tell me which product I need to buy? Thanks

I need an 1/2 in wide, 21 in long channel balance.

21 inch long, 1/2 inch wide, stamp shows 2040, brand is Pella vinyl window. 9 bottom feeding has a roller, kind of like the middle example picture.

Looking for assistance in ordering the correct replacement parts for Milgard channel balances. They measure 21" in length and the stamp says 20 3 JV CMC 2. And advice would be great.Emily

How are you? I need help buying a balance the stamp in the balance shows 2040. I'm assuming your 20 series 390 will be a good match, but i want to be sure. It's about 20.5 inch. long, i hope you can help me. Thank You so much.

Hi, looking for replacement for CALDWELL 20 4 EQ window channel balancer. Enclosed please find 5 photos. Current balancer's metal piece length is 21". Thanks. Warren

Need to know which replacement part to order. Thank you

See attached pictures, I cannot figure out the s series to replace them, thx have more pics if necessary

need balance 1/2" channel width non-tilt 21 inch 10-15lbs