Viewing all customer Discussions for:

S380-27 27" Series 380 Channel Balance

Can you help identify these window balances please

Hi, I hope you can help me locate balancers for my windows. The stamped numbers are " 26 4 cx cmc 11"Thank you!

The part S385-27 is the right one

Hello, I'm looking to replace this block and tackle for a Millard Ultra series. I believe it is the S380-27 (bottom width is 1") but if you can confirm that would be great. Thank you.

metal length is 27" with stamp (26 4 FT CMC 2)

I am looking to replace the pictured part. I need a quantity of 6. Likely will need more in the near future. Can you provide pricing and lead time? Is there anything else you need from me? Thanks for the help, Graham

I am seeking a window channel balance 27" x 9/16 x 5/8 for a 32 lb window.

I am trying to find a replacement for the channel balance on my window as seen in the pic. It has trouble recoiling back up when opening the window. It is 27" long (also 5/8" wide) and stamped 26 and 3 (as you can see in the picture. I'm not sure what the 3 means or which channel balance to or ... (cont.)

Hello, This is the first time I've tried replacing these and I was hoping you could help me to identify which balance I need. In addition to the photos provided, here is the writing that was on the balances: 26 3 JV CMC 2 They measured 27 inches long and the width looks to be slightly larger than ... (cont.)

27 inches Mark shows 2630 Let me know if you have any questions.

Older single hung aluminum double pane window, need replacement. Windows old enough no numbers/model stenciled on window. Total length balancer 28" aluminum 27 inches. Do I need to weigh window or is this enough?

Hello Swisco, please assist me in identifying the photographed window balancers which are marked: "3330," the longer one, and "27 3," the shorter one. I was told the one marked "27 3" is a "27 30."I currently need four (4) of the "3330" balancers, and two (2) of the "27 30" balancers. Please let ... (cont.)

My window balance has a stamp number of 26C USB, what is my conversion? It is 27" long, .5" depth, with a 1" winged guide.

I need 27" channel balance. Photo upload. Please help me to identify the correct one. Thank you!

Can you please advise one what would the a pro type of this so I could order? Thank you in advance!

Good afternoon I need to order two of the pictured channel balance. What size or stock number channel balance should I order to replace the one in picture. Thank you

I need help to determine what length channel balance and plastic piece that goes in the top of the window so we order correct size.

Need help with what part to order. Here are the markings on the current part: 26 3 DX CMC 11. Also, refer to attached photos. Let me know if you have any questions.

The Metal is 27inches long

Hi, 1. The thread on one of the balance broke. Please let me know my balance type. 2. Can I get the thread to replace or better to get a new balance? Please let me know my balance type. Thanks, Siraj