Viewing all customer Discussions for:

S390-27 27" Series 390 Channel Balance

Do you have any of these rails? I would need 8. Thank you, Steve

Hello, I am unsure which part this would match to. I think 390 but not real confident as it is a little different. It says my windows were mfr by Gienow Building products. Length of metal part is 27". Please let me know if you need any more details or pics. Thanks!

Attached are pictures of my channel balance. Need to know which one I will need before I order. Length is 27 inch measurement. The rest is on pictures provided. Thank you!

House is from 1986 old windows. Windows do not stay up. Need new channels. Channel completely broken Part identifier - B.S.I. 26 C Channel length 27" Width - 1/2 " Window weight - 15.5 lbs

I would appreciate your opinion prior to order these, will need 30 units. The metal is 27" long and the bottom shoe is 1" so it appears that the S351 with 2640 is the correct replacement. The stamp on the metal is 2640 with a special character after the number. The 18-09 appears to be the best fit o ... (cont.)

The length is 27 inches and the width is 1/2

Thanks for the help!

Looking to replace two channel balances in a non tilting window, the balance measurers 27" long by 0.5" Trying to figure out what product to order from you? IS there anywhere in Canada I can order from? Thanks for your help.

Here are photos of the window channel balance we need. THANK YOU!

My name is Roman I just need a little information on the right part to get the measure meant on just the steel without attachments is 27 inches. I need four of these parts. Thank you Please contact me

hi, I had the springs break on a few of my balencens and am looking to replace. They are 27" long, and on the side it has 2640 imprinted on it. Attached are photos of each end as well as what was listed on the window. Any help is appreciated!

26 4 Caldwell JM 27 inch

I need to order some replacement balance rods, but I wanted to make sure that I'm ordering the correct part. These are for a Linford window. The rod is 27" and is stamped with a #2640.

IS PICTURES OF ENDS WANT TO MAKE SURE IM ORDERING CORRECT BALANCERS WE HAVE PURCHASED FROM YOU BEFORE THE BOGEN LOFTS AND THE THE VENTANA LOFTS MAXUS PROPERTIES ( MAY HAVE IN YOUR SYSTEM) THE CHANNELS HAVE 4 NUMBERS LIKE 2760 2650 3470 THE WINDOWS ARE NOT TILT OUTS, NOT GROVED ,AND ARE 1/2 WIDE CA ... (cont.)

Hey I have a bunch of these balances and it's very hard to open or close my window I'm looking to upgrade the hardware

Balance specifications are 29" length x 1/2" width, stamp is 2630 BS. Top yellow fitting is 1 1/4" length x 1/2" width x 1/2" depth. Bottom black fitting is 1" length x 1/2" width x 1 1/8" depth.

Hello, looking to confirm part required...thanks

from a 3'0x 5'0 aluminum milgard

Hello, Due to lack of stock, some of the channel balances meant to support lighter windows are out of stock. If I purchase ones that are meant for heavier windows, will it have any negative impact? For example, getting the 2550 instead of 2530, will that be a problem? I attached pictures of two ch ... (cont.)

It says 26-3 KX CMC 7 Looking for a replacement. Thank you!