Viewing all customer Discussions for:

S390-29 29" Series 390 Channel Balance

This is a 29" long spring lift. 29" is the length of the metal part only. Metal part dimensions are approximately 5/8" square.

I am looking to replace the channel balance in my windows. The window is a non-tilt with fixed panel at the top. The sticker reads as follows: Series 2312 AAMA/NWWDA 101/I.S. 2-97 H-LC50 48x84 How do I located my replacement part? Thanks Gary

Window latches say garden rooms by Coleman. The metal only part of the balance is 29 inches. With the plastic pieces at the end of it it measures 30 inches.

Thank you so much for having this site on line. With your great video it only took me about 5 minutes to replace both of the balance rods on my window. Great video. And I am a woman 60 years old and if I can do it anyone can. Thanks. Nancy

The house was built in 1998. I have checked and cannot find any markings except "CALDWELL". I also need the plastic piece the fits on top of the movable window and sits in the window channel. and is attached with a screw Any assistance will be wonderful. Thank you in advancePaul

I would like to purchase a 2 complete Channel Balances: Part #2830, 29 inches long. I need 1 set of two. Thank You

28-13/16" long. #1 in position. #2 bottom. #3 top.

Please help me determine the correct part to order. Attached are some images. Can someone help me figure out which part to buy?Thanks

I have some block & tackle non tilt window one stamped 2820 measures 29inch long the other is stamped 1620 measures 17inch measures 17 inch long can I just order them by the stamped number and get them complete with the shoes?

Jordan Aluminum Window 1994 year. The channel balance code show to be 28 4 CN CALDWELL. The channel balance is 29" long.

These are 1/2 inch wide, and the only number marked on them is 3010A and 2810A

I can't find any numbers printed on it. They have been smeared off. I need 2 of these.

It is a hanch wide and 29" long I need four of these

Jordan windows, double pane insulated Part Number ? Left : 2830F Part Number ? Right : 2830 Sash Weight 18.6 lb Please see attached photos for upper and lower fittings. Thank You.

I am looking for replacement channel balance, marking on the side says caldwell 28 4 AS, this is a non tilt window. Theres also another balance that says 28 3 ES.

What series do I need for my type of channel balance. I have a few different size windows. They have marking of : 16 2 28 3 28 4 28 2

aluminum lower sash. 23 lbs. need 8 29" balancers. There are no markings anywhere on the window or balancer. I also need the stoppers that fit in the top of the sash. It's IMG_0156 held in with 2 screws

Hello, I am looking to replace window balance. Circa 1987 please see images

It appears to be a 19-002 top and 15-003 shoe, but I didn't see a reassembled guide with those parts. What do you think? Would this be a custom order? Thanks

I am a maintenance person at a school. I have two Alenco windows that I believe need new support balances. The two windows appear to be the same size. Each window had different support balances. One had two 2730's and one had one 2820 and was missing the other. I need help trying to figure out, base ... (cont.)