Viewing all customer Discussions for:

15-198 Balance Clip Attachment

I would like to buy 2 Series 795 channel balances (28B) with the 15-198 hook attached, and 1" closed cam shoes. (I think 15-194) Can I buy the channel balances with the hook attached? ...or do I need to modify them myself?

Hello, I need four window channel balances (model S795-33C), but with a balance clip attachment installed so that it can fit into a square hole. Could you please let me know the cost for these so that I can place an order?

Need to know which part(s) to order. Right channel broken. Will order both new so balanced. Is part same for both? 32" long part. Also white parts were by window. Are these part of window somewhere that you know of? Thanks for your help.

I have a broken window balance and I'm trying to find a replacement. I took pictures of all the pieces I know are relevant but let me know if you need anything else. It says 39D on the side and I think its a closed cam(pic attached) 1 1/4" . It also uses a clip to slide into a squarish hole(att ... (cont.)

20 of your S795-27, 27G window balances with a hook as the top attachment

need to know what replacemen parts i need to order to replace the existing balancer

Good morning, Looking for a replacement block and tackle setup for Pella, circa 2010 manufacture. I am able to reuse the existing shoe guides if needed. The original block and tackle fit very snugly into the side channel of the window(FYI). Look forward to your response. Thank you. Eric ... (cont.)

Can you please tell me which part to tor order to replace these for my double hung , tilting windows ?

We have the same one, but with a hook. Do you have a counter balance for that?

Says it's a 18b but that is all I see can you help tell by the pictures

Can you provide a cost for this balance? It appears to be a S795-27 with a 15-198 clip. I need qty 4 (2 windows). Thank you

33B inch tilt window balance with a hook on top. Similar to your S795 but with a hook at the top....what is your price and lead time?

Balance is 27 inches long.

Need a replacement part

Hi Swisco Help Desk,I recently purchased two new balancers but didn’t pay close enough attention to the details. I need a 1" T-Lock Balance Shoe, Open Cam (Green - 15-194) instead of the 1-1/4" T-Lock Balance Shoe, Open Cam (White) that came with my order.Additionally, could you please verify from t ... (cont.)

I have some windows that need some combo of T-Lock Shoes, Channel Balances, and pivot bar. Some of my pivot bars rusted and broke off still stuck inside the T-Lock shoes. I have attached pictures of the pivot bar, T-Lock, and Channel Balance. I think I know what parts I need for the channel balan ... (cont.)

I ordered 2 of the S795–32. it appears I need additional parts. I saw another post where you created a custom order for the customer. I included it as a picture. Could you help me order the correct parts. Am I able to keep the S795–32 and add the additional parts myself? It looks like ... (cont.)

Need please S795-28 (28G BSI) with the 1" wide 15-194T-lock shoe and 15-198 clip, need price for 4 units , I understand it's a custom order, how long usually takes to get to my address and how much could be with delivery

10 window Balance 28c T lock The is the balance I have please let me know if this one you havein stock or I need to be ordered

Hello- I was told my window needs two balances. I have measured the balances at 27" and have identified 27D H0 on the balance. I have attached pictures of the measurement of the balance, the stamp, as well as picture of possible other parts I may need for installation. Can you please let me know whi ... (cont.)