Discussions for S385-27 : SWISCO.com

Help to identify the part

Hi I was wondering what part I should buy from your website The number id I have is 26-4 LX CMC 11

+1

Looking for these window channel balances

See pictures. Metal part is 27" long. Thanks.

+2

26 4 window balance 1/2" milgard window

Please advise which part number would be the replacement for the attached photo/description. Thanks

Replacement Channel Balance

Hi, my old channel balance does not have a number on it. Which would be the correct replacement part?

+7

balancer ID request

Hello,My broken window balancer is 27 inches long, has markings "26 4 HV CMC 2", is from a Milgard window.Thanks,Mike

+2

Caldwell window balance, stamped 26 4

On the part it is stamped with 26 4 JP Caldwell Please help me to identify the part number. Thank you

Replacement balancer

The attached files show the balancer I wish to replace. It is stamped 26 4 HS Caldwell and the metal channel is 27 inches long. Let me know if you need any additional pictures to determine the correct replacement. Thank you, Ed

+2

Do you sell these milgard balances?

I need replacements for milgard window balances. Steel part is 27" depth is 10/16" and width is 9/16". Have attached pictures. I see a post on your site for someone else that had same model number, 26 5 GW CMC 4, but the recommended replacement didn't match the measurements on my balance. Any he ... (cont.)

+1

264 LW CMC 7

I had the string snap on the other side. Looking to get replacements for both.

+5

Balance ends

I need 2 of these to replace the one that broke. I ordered from Amazon but came with the wrong ends. Can you help me out

+6

Balancers Order

I have sent an email to help@swisco.com and attached photos here and there. The old channel is 27 long, the walls of the channel are 1/2" wide. The hardware at the ends are a little bit beefier than the balancers that I ordered. The email is long...

+2

Replacement part identification request

I'm looking to replace a 27 inch with the markings 26b. Thank you.

+1

Non-Tilt Channel Balances

Hello, I need help with identification. It's marked as 26-4 Caldwell LL and measures 27" from metal to metal. There are wings on both top and bottom guides. I believe these could be a match for the 380 or 385 series, however when I measure the foot depth, I seem to be right in between 1" and 1-3/32" ... (cont.)

+2

Need to replacement balancers complete

Hi one of our Windows does not have window balancers at all so we need to replace those missing completely

+2

Channel Blocks and Pulleys Window Balancing Seals

26 5 LU CMC 1

+5

looking for a part (window balance 26-3 IX CMC 11)

Hi I am looking to see if you guys have this window balance available. I attached 5 photos of the part that I need to replace. Thank you

+2

Window Spring Replacement

Hi, the spring is about 27 inches long. Window sash weights about 22 pounds. The springs shows numbers 26 9 JW CMC 7. Can you tell me what part to purchase as a replacement?