Viewing all customer Discussions for:

39-061 Keller Window Crank

Looking for both left and right side window cranks for awning windows. Looking for white color. See attached photos - bottom holes measure 1 3/8 inch and length holes are 5 1/4 inches. Please let me know if you have any that would work. Thanks!

Looking for the part number for this awning window operator to order. Thank you.

This is from back porch window...

looking for a replacement jalousie window crank. the house was built in 1978 and I would assume the windows are original to the house.

Good Morning, My window crank handle detached from the operator with a metal screw attached. I tried screwing it back in but it won't thread. The window still opens/closes manually so I believe the problem is with the handle. Please advise on best route to fix/replace.

this handle will open the window but when i try to close it the handle unscrews from its base, do you have a replacement ?

I have a need for a window crank which I believe is a right hand version of Product Code: 39-026. Are there any differences in these? The one I am replacing has no markings nut is stamped KD JAL on the inside of the tabs where is attaches to the frame. It is silver in color , not white, but color ... (cont.)

These jalousie windows are from the late 70's. I would like to replace the crank and get them working againMack

Will one of your products replace this? Is this a right or left crank? Thank you

This is the part that is on the side of every window pane frame that projects from the edge of the frame that when you close the window sits under the claw in the mechanism and locks the window as the crank is turned and draws the window up and in.

Silver line crank and window case 5.9"x 2.05" from screw end to screw end

The hole spacing for the bracket is the 5-1/4" top to bottom. The operator link arm is 2-3/8". The issue is the handle comes out of the operator when closing counter clockwise at about 30% remaining before secure. Operator can open windows fully and bring them back in to some degree. Sunroom was ins ... (cont.)

1717R stamped in side

39-061 Keller window crank - recommended lubricants

Hi, the part is plastic and it breaks so it can no longer hold the metal hook. Do you have anything like this? Thanks

Hello, I am needing a RH crank system for my old house windows. It has serial numbers etc PAT.NO. 198202 U.S, 2 RH,RD, 1963 CAN. If you need any other information please email me Regards Charlene

vertical height, edge-to-edge, is 6" vertical distance between mounting holes is 5.5" horizontal distance between bottom mounting holes is about 1.05" Entire crank operator shown in photo needs to be replaced (not just handle)

Have casement windows in my atrium, house is 30+ yrs old and I've owned only 8 so have no idea who made windows. Had one crank replaced by local co. but the service was horrid. Need to replace 1 left and one right had crank, thus 2 cranks. I measured 5"1/4 for the body of the device. Silver. Ho ... (cont.)

5 1/4 inch tall 1 1/8 inch between screw holes at bottom Screw hole at top offset towards side 2 5/16 between holes on arm 3/16 hole at end of arm

Crank is located on left side of window it operates. Handle seems to Have stripped inside so I need entire assembly.