Viewing all customer Discussions for:

39-505 11-3/8" EntryGard Track, 4 Hole

I'm searching for some Millard window casement operators. The number on the casting is 40471. Thanks.

Here are photos of two different operators. First one is a 45251. Second one has numbers on parts, 20544, 30470 L.H. and 30636. I need to replace both of them.

I would like to find replacement parts for casement windows. I've attached for photos of what i'm looking for.If possible i would like the colored parts black, crank handle and the window latch. The other pieces it doesn't matter. This window is broken it appears as if the screw is gone.Basically ... (cont.)

Recently moved in to our house and found one of the windows fell off the hinges. Looking at the markings it appears to be a two bar hinge that someone else also posted about(pic 1 with all the measurements). Would you have those in stock? My house was built in 2008. Thank you.

L 31538A on the part, the winder is inoperable.

Please if you know which crank this is

I believe this is a truth part. Say LH as can be seen in picture Also the arm has this number 501-11-3L

can you tell me what i need?

When I cranked the handle no longer catches to open or close the window.

I need replacement hardware for my window. Was able to see the words, Entry Gard Truth and the numbers L30841 and 20810. Please see attached photos.

Need to replace rusted out mounting to crank arm?

Hi i have a home full of 20yr-old Norco series D crank-casement windows. All have "Truth" single-arm mechanisms. The little "button/wheel' at the extent of the arms on very many of these windows - the button that inserts into guide the rail - falls out of position. Maddening. I am constantly having ... (cont.)

I just bought a number of the biege 14 1/2" tracks, and they are not going to work. This is a simpler track, with a cutout in the bottom to allow the operator "wheel" to snap in place. Four #7 screw holes, and not much else to distinguish it. I need a dozen or so. Thanks!

I am looking to replace 3 window arm operators. Please let me know if you have them, and how much each will cost. The info. on the arms reads as follows: R30842 - This one opens the window to the left I need one. 51538A - This one opens it to the right - I need two.

The primary concern is the nylon roller, which does not remain in the track and frequently pops out of the groove, especially halfway through opening. We find ourselves having to push it from the bottom to keep it on track, limiting us to opening the window only halfway.

I need window crank left side and the metal under window the long arm slides on.

Hi, I'm trying to replace the window Operator the bolt's teeth in the second picture has snapped off and is stuck inside the third picture. The brand is by Allied Windows which has run out of business. Please let me know if you have this part. Thanks!

Good morning. The window is located in a ocean community home so rusty is an issue. I need left hand and right hand operators, tracks and hinges. Hinges for top and bottom please. It's a bay window that still has the glass sealed. Amy help is appreciated

Looking for milgard casement window operators parts number stamped on #40753 on long arm, #31538A on short arm. The subject windows are approximately 25 to 30 years old and The operators were worn out. Please quote, thank you, Tom

I have 2 casement windows, both about 20 years old, where the roller/bushing is popping out of the operator track when the arm is cranked out to approx. the center of the track. Do you think it is an issue with the bushing/roller - or something else? If the bushing, is that available by itself? (par ... (cont.)