Viewing all customer Discussions for:

15-111 Pivot Shoe, 1/2" Thick

I believe my windows are Simonton or CertainTeed. Approximately 25 years old. Any part numbers are absent/illegible. Bottom sash weighs 20.4 pounds. Require part numbers for replacement roll springs, supports, bumpers, lock shoes, and sash pivot bars if required. Photos show installed/broken, ... (cont.)

No Markings, see pic for dimensions

I believe these are old MI or Alcoa windows 3050 call size, sash weighs approximate 35 lbs

I need help with replacement hardware for this type of window.enclosed is bar code of window and hardware i removed. This is for 2 windows . Each window measures 33. 3/8 inches x 23inches. If I guess the weight of the one window each 20 to 25 pds. . Thank you.

Hi, I need a left and right replacement window pivots. I have photographed another window where the pivots are intact, the ones I need to replace had the point part that engages the "spring" break off. None of the window pivots in the pictures look quite like what I have installed. The windows I ... (cont.)

Hello, I need to replace the window coil balance but not sure the size or what to get. Can you see from photo what I need? Appreciate the help

I'm looking for replacement part for window coil springs the upper spring says Omega 6.5 33 in the bottom spring has the number three stamped on it any help would be appreciated

Coils are 1/2" width. Possibly 33" long?Top and bottom balance support parts are both 1.25" width I can't find these parts anywhere. Please advise! Thank you!

Side metal slider that keep windows open

We are looking for replacement parts for some windows for a Customer. I am unfamiliar with these, but upon research it looks like the parts you have listed, could help us out. We are currently looking for pricing. And unsure of quantity at this time. I am not seeing any numbers or markings on ex ... (cont.)

Hi there, I have a window that won't stay open because the coils have snapped. It has 3 coils per side on each window. The markings on the coil show 33" P # 3.5 5232208 on it. The cover at the top has markings patent #s 5.232.208 - 5.365.638 - 6.584.644 B2 FAS # 10246Can you help me with the parts I ... (cont.)

1st picture-shows window label 2nd pic-pivot shoe or lock (not sure the correct terminology) Also need the coil springs that run from center sash side to bottom dash side. Need internal tilt latches R & L

My windows are about 30-40 years oldA few of my windows won't stay up.

I need two window spring kits

Hi! I'm looking to ID this coil cover. Its twin was broken and needs replacing

I'm in need of replacement parts for single hung sliding windows and instructions for installing please The glass /sash weighs 22 lbs so I will need the right coil springs too please send recommended parts and instructions for installation thank you

It looks like the springs on both sides of the window are broken. The channel is 1.25" wide. I didn't get a picture still installed(at our cabin, but could get them later if absolutely needed) The window sash is 28.5" wide. I haven't weighed them, but they are a small bedroom window. Maybe you can d ... (cont.)

Hello - I have a double-hung Simonton with a 1999 mfg. date that has a broken spring balance on one side. Can you provide a recommendation on parts to replace?

Looking to replace coil balance and pivot shoe, but unsure what parts are compatible. Seems like this particular setup is either discontinued, or just hard to find.

I am looking for replacement pivot lock shoes for my 1996 Simonton white vinyl window. The attached photos of my original lock shoe shows the top length is 1 1/4", the height is 1", and the width is 1/2". My original shoe looks to be the exact same size, design, and shape as the Swisco 15-111 pivo ... (cont.)