Viewing all customer Discussions for:

18-042 Top Sash Guide Pair, Pan Am

I do not know what it is called, but this piece goes on top of part #1820 channel balance. I don't want to take it apart, because it will be useless to me after that if I cant order new parts. I am hoping you have a good idea of what this is and how I can get it. I am having a home inspection Tues ... (cont.)

Hello, Can you please try and identify the type of Channel Balance in the attached photos. The channel is 24 ins long (excluding the top and bottom plastic fittings). It is stamped marked 'C 23-2'. I also need the plastic stop caps on the window that retains the channel balance in the window frame, ... (cont.)

I need (2) 31 inch balancer stamped 3030 with the ends per photo along with (2) of the clips that screw the window. The balances measure 5/8 one side 9/16 the other without a rolled edge.Call me if you have questionsThanks

Single hungle side-load block and tackle window with a plastic take out clip.

Hi I also need 4 of these balance tops

Hello, I was able to use your guides to identify the new clips and balances I needed but when I was installing them I realized I need to replace the top sash guides too. I'm having trouble identifying the correct part. I attached a picture of my recent order if that helps identify a corresponding t ... (cont.)

Non-Tilt window only markings on the channel balance are 3020 width 1/2" approx 31" long home built in 1981 Also the top of the window plastic piece is broken (see pic - where window balance has pushed thru);

Non-tilt window only markings on the channel balance are 2320 width 1/2" approx 25" long Home was built in 1981

The window manufacturer looks to be Binnings America. Can you see enough to recognize this top sash guide?Some additional photos from an in-tact part.5/8" wide7/8" tall9/16" deep

above are pictures of part. The number is hard to read. Need two.

Hello, I recently ordered channel balances but did not realized that the sash supports are broken and I also need some pan am take out clips. I think I have found out the part number for the clips but I cannot find the sash support part number.

I just want to confirm, they look like your S377-30 (since they are 30" long, not counting the plastic). It is stamped: r 29-5. What weight would I need? Also, I need take-out clips and a top sash guide. Thank you.

HI, I have a few broken of this plastic guide from My Binnings/Pan Am BIN-3 Single Pane Window. Could you please let me know what the item is so I can order it. As you see one is broken and one is not. Thanks so much

I need to know what part to order. I need 4 of them. Two different windows

I need channel balances and window locksthank youPeter

Hi there, I think I can get the gist of your photos! Does the 18-042 look good to you?

Has no identifying numbers or names it is a top sash guide on the window frame

Good afternoon, i am having diffuculty identifying which replacement part to choose. the current balances have different Id #`s. one has number 2410 and the other 2320. can you please advise? these are 1/2 inch channel width. thank you in advance

These are from Binning's Pan American windows I installed when building a new house on Marco Island,FL in 1985. The pictures are from two 25 single hungs. The channel balances measure 31'long and work fine yet after some lubrication but I have a broken left top guide on one. I also have a 13 sin ... (cont.)

White plastic piece at bottom of channel balancer. The only number on the channel is 2320. Other channels that are the same size say 2340.I need the stop that is on the sash that, when missing, allows the channel to spring up to the top. (photo in this post). Also need the bottom plastic piece tha ... (cont.)