Viewing all customer Discussions for:

S380-29 29" Series 380 Channel Balance

I just returned the 28" series 385, 2750 and it was 2" too small as the original channel measures at 29". Which on would you recommend?

Florida Extruders, the manufacture, is out of business. I have several windows that the springs have broken. Balances measures from metal end-to-end 29" with a width of 9/16". Channel is stamped with 28F only. Other information from the label on the windows is: Car # 279-170 Model 1000 SH Rating: ... (cont.)

Believe they are 1/2 " wide and 29 inches with a Stamp of 28G Struggling with specifc type/model - several look similar. Photos are of top and bottom. Need 8 and have impact windows

I have this length is 29", 5/8" wide channel, with stamp 28B.

Looking to confirm adequate replacement part number. Existing window is non-tilt, channel width is 1/2 inch, length is 29 inches, and bottom shoe is 1 inch deep. Is Series 380-29 with Option 2840 correct?

1/2 inch non tilt window balance 29 inches long Engrave with number 28 4 t BSI

message

The length of metal channel is 29 inches. The stamp reads 28B USB. I am not sure who manufactured and when is was made (though likely in 2005ish). I need two for now to make sure they do work.

I'm stuck on the series needed so I will upload pictures. Help! its 1/2" wide, 29" length I will get weight tomorrow when I go to my mothers house. Markings are gone.

Hey Swisco, Please help identify this windor balance. It looks like the old stamp is 28 3 Thanks, Scott

Can you quote for a pair of replacement balance springs identifiable from photos Thanks Nick

Good afternoon, I need to replace my window balancer. 29", please help in identifying the correct product needed.

Has 28C stamped on it. Both sides broken. I imagine it is a cheap window. Miranda built house

Hi, I am looking for spring balances for my Non Tilt windows in a 2006 block home in Florida. They are big and heavy windows (68"x52" approx) The Stamp reads " UB 28D" from what I can tell. See photo. The lengh of just the metal is 29" Need to replace balances for 4 windows.

We measured width and reads 5/8 balance has stamp that reads 28AUSP

Stamp 28D. Window size 26X62 inside. Shoes on base of window sill.

Hi I have a windows do not stay open these windows were installed in 2006 , the balances are for non tilt windows, 1/2 wide channel balances as what I see part 28D or 280 not sure .... stock doesn't show which parts I need please help thank you

Markings on item say 28b usb

Good Afternoon, I'm in need of new balance pieces shown in the attached pictures. When I measured the piece it came out to a little bit less than 29in. When I looked up the code on the piece (2850) on the website, a completely different piece came up. Please help.

My tension rod has fallen down & I can't figure out how to get it out. The number in the picture is that the stamp identification?