Viewing all customer Discussions for:

S385-27 27" Series 385 Channel Balance

The metal is 27" long, 1/2 " wide. The stamp says 26-4 DE5 CMC 54. I don't know the manufacturer of my windows. I need 8 sets to replace all balances in 8 windows. Please see pictures attached to help find correct part. Thank you for your help.

Good morning,I am in need of assistance to identify the right channel balance for my window. Looking over your website, the top nylon fitting does not match to the units shown, as there is an additional notch on mine. Below is the data I have collected to go with the attached photos.Window: Milgar ... (cont.)

Need a pair of replacement Milgard Channel Balances, stamped 26 5 HR Caldwell. End cap seems to be 1-1/16th inch (I think your 15-004 is supposed to be 1-3/32 but tough to measure to that) I believe it is your 27" Series 385 Channel Balance Photos attached.

Hi, Wondering if you can help in seeing if you have replacement balancers for this Milgard window. The part I am looking for has the following stamped onto the balancer:26 3 HU CMC 2 I have attached photos of the balancer with this message.Thank you so much,Nicci

Hello, Could you please provide me with the correct part number on your site to replace this 27" window balance? Thanks, Paul

Can you know what size do I need to buy ?

1/2 inch wide. 27 inches long, (not including the plastic ends). Milgard window decal inside the frame, but no markings on the balance. I also need to order some of those metal springs that go into the side of the frame. Thanks!

I WOULD LIKE TO PURCHASE WINDOW BALLANCERS 26 GW CMC 7 AS THE ONES INSTALLED IN TWO OF MY CONDOS WHICH I RENT OUT HAVE BAD BALLANCERS THANKS JOHN

My balance shoe is a little thicker than yours. Any chance this has to be custom made?

I need to replace (4) 1/2" Wide Channel Balances with a length of 27". The stamped number is 2640 but I'm unsure on the attached endpoints.

Can you help me get these replacement party? Thanks

One of these broke, should I replace both? This one is 28 inches and the window is 36 inches wide.

My channel balance reads 26 5 HW CMC 7. Not sure which stamp I need to get if any. I?m guessing it?s the 2650 but the space between the 26 and 5 is confusing me. Please help, thank you.

Trying to determine if you carry the replacement parts for these channel balances. Our windows are non-tilt & the balances are 1/2" Thank you for any assistance! Margaret

Hi Guys, Can you please identify this balance, it is 27 inch long and has 264 Caldwell Dm stamped on it.

Hello,Could you please help me identify which chanel balance I would need. The with on the photos provided is 1/2" and the height of the metal part is 27". Best,Jenny N

The info stamped on my channel balance says 26DS 36.The metal measures at 27 inches. Can you help me determine which replacement I need? Thank you!

I have 20 year old Mercer vinyl windows that one of the spring lifts cords broke. Images are attached. Total length is 28 inches. The markings are in the third image provided.

1/2" wide & 27" in length

Metal measures 27" long and it is 9/16" wide. Stamped on back is the following designation: "26 4 BV CMC 2".