Viewing all customer Discussions for:

15-150D 1/2" Coil Double Support

Printed on coil I think can read #35 33" the width is 1/2 inch, tongue is 7 mm, the hole is 9mm I think this is a Jeld Wen window purchased in 2017. No stickers or identifying information on window or glass.

window coil spring broken. waiting for jam spreaders to remove old parts

Hi, pls refer to the picture attached and advise which part is this and also the part that needed to hold the operable window.

Could use some help picking out the right coil spring

Hi , can you help me identify this product? My window is a simonton

Picture of part and picture of manufactures sticker.

I believe my windows are Simonton or CertainTeed. Approximately 25 years old. Any part numbers are absent/illegible. Bottom sash weighs 20.4 pounds. Require part numbers for replacement roll springs, supports, bumpers, lock shoes, and sash pivot bars if required. Photos show installed/broken, ... (cont.)

Hello I need help to figure out what part I need to replace this window balance spring. I do know it is a double spring setup. I believe I ordered one from you 2-4 years ago and this is for the same window. Don't know if there is anyway you can look up what I ordered last time through my name. Todd ... (cont.)

I believe these are old MI or Alcoa windows 3050 call size, sash weighs approximate 35 lbs

I need help with replacement hardware for this type of window.enclosed is bar code of window and hardware i removed. This is for 2 windows . Each window measures 33. 3/8 inches x 23inches. If I guess the weight of the one window each 20 to 25 pds. . Thank you.

Hi we have Simonton Single Hung Windows at our coastal home. The windows were installed in 2005 when the home was built. I need to replace the coil balance in the window. What is the best suggestion please?

Hi, I need a left and right replacement window pivots. I have photographed another window where the pivots are intact, the ones I need to replace had the point part that engages the "spring" break off. None of the window pivots in the pictures look quite like what I have installed. The windows I ... (cont.)

I'm looking for replacement part for window coil springs the upper spring says Omega 6.5 33 in the bottom spring has the number three stamped on it any help would be appreciated

Hello,My home is in Eastern NC and built in 2006 with double paned windows containing coil window balances. Almost all windows have some or all portions of the balances damaged. Some are hard to open some do not stay open etc. Id like to simply order entire already assembled left and right balances ... (cont.)

Coils are 1/2" width. Possibly 33" long?Top and bottom balance support parts are both 1.25" width I can't find these parts anywhere. Please advise! Thank you!

Can you Please help me with those parts ? number on spring is #8 thanks in advance

I'm pretty sure I also need the 15-191 pivot shoe (for a 15 year-old Milgard Tuscany window). I also need the coil spring. The only markings I can find on the spring are #7, 5 35. Do you know what part that might be?

1st picture-shows window label 2nd pic-pivot shoe or lock (not sure the correct terminology) Also need the coil springs that run from center sash side to bottom dash side. Need internal tilt latches R & L

Hi! I'm looking to ID this coil cover. Its twin was broken and needs replacing

I'm in need of replacement parts for single hung sliding windows and instructions for installing please The glass /sash weighs 22 lbs so I will need the right coil springs too please send recommended parts and instructions for installation thank you