Viewing all customer Discussions for:

16-002 Take Out Clip

Metal length is 31 11/16 31DS 3.S.I. RH38 I have more pictures if allowed

Hello! I'm trying to figure out what channel balances I need to replace my old ones. The measurements are 1/2" width, and I *think* 32" length, but it seems like it might be just slightly under that (see photo). I also found a series of letters and numbers etched into the balances starting with 3 ... (cont.)

Hello, I'm looking for the replacement parts in the included picture. They are the top plastic cap on the window that captures the top of the balance spring in the window frame, and its associated square drive screw. I would also like to order the plastic guides (four per window) that keep the metal ... (cont.)

Hi. Would like assistance identifying part. Balance length = 21" I would like to purchase the correct balance, and Takeout clips. Please advise. And thank you for your assistance. -Ray

The metal pieces are approximately 1.25" in length x .25" in width and allows the window channels to be installed and removed. They hook into a small square opening at the sides of the vertical window frames.

I need some replacement balances for our single hung Cascade Windows. They are stamped 23 4. And we need a replacement take out clip.

the silver balance is 23 inches and has the numbers 2220 on it and we also need the small silver piece in front of the balance and also the white plastic piece... if we can get the window balance as a whole that would be great and we would like 16 of them

I new two new replacement balances and a couple clip releases

Hi Folks,Please take a look at the photos and let me know the part I need. I will need 12 window sashes. Thank you.Ken

Window balances Sizes 14, 15, 21, 22, 24 Two way single switches Window clips Dust caps for the windows Tri wing screws for the window guards L brackets

Looks like I have 19-005 Balance Top with 15-029 balance shoe. Looking for non-tilt 1/2" channel balance assemblies. Also need sash stop and clip on side of windo.

This part is approximately 1/2 inch wide and holds the channel rail in place while under tension. These windows are hurricane impact and are removable.

Hello, We have Milgard windows and are missing a few items and are having trouble determining which parts to order. We are missing a few metal clips that flip out to allow us to remove the window. We are missing a few breaks that stop the window from opening too far up. Can you suggest which par ... (cont.)

Looking for missing side clips as well as solution for broken part of lower removable window sash. These are impact windows. How difficult is it to replace missing clips? Do the window need to be un-installed? What to do about the broken corner on t

mine is 23 3 is 23 3/4" long looks like your # S395-24 also do 16-002 take out clip replace plastic ones ?

Would like 6 plus a few take out clipsJohn

Hi, I've attached photos: - One of a metal clip-like part (I don't have a photo of it in place, sorry)- Two photos of a plastic part--one in the window mechanism and one that is broken off.These were located when we replaced Series 385 channel balances in four windows (three 33" and one 27")and we n ... (cont.)

I have a GA 5500/4000/4200 SH series window and need the metal clip that goes on the side of the frame to keep the window from falling out when raised.This is the additional information requested. I need the silver, metal clip that stops the window from raising too high. As you can see, without th ... (cont.)

I would also need the balance stop that sits in the window frame.