Viewing all customer Discussions for:

S380-29 29" Series 380 Channel Balance

I need a set of 8,the lights is 29 inches

This channel balance fell out of the frame of my window. It is identified with a stamp of 28B USA. It measures 29 inches long metal end to metal end. The marking is not visible in a photo.

Total length of the channel is 29" x .5 The marking on the channel is 28C The plastic foot is 1" and has a 13 on it

Hello, I have attached the photos of the old balance. Can you please tell me which replacement I need to buy? Please include the correct top and bottom guides. Thank you.

The only markings I have are on the outside of the channel UB 28C. The spring dimension is 14" body length x 1/2" diameter

Hi, I was hoping you guys might be able to assist me. I recently purchased some channels believing they were the ones I needed. My order number was #1779801 but upon first look, I want to say I purchased an incorrect one. I was hoping that with these pictures included you might be able to tell me th ... (cont.)

Can u help me find this balance has 28 c on it

Old Castle is stamped on the window. I think I need P/N S385-29 (both sides) and definitely need the sash stops that screw on the window itself. "28D" is stamped on the sash. 265-2 5E is also stamped on the sash hardware. The nylon stops on the window are broken. Thanks for your help with the ... (cont.)

hello, please help me to find these plastic clips i need on a 28b balance, thanks

hello, please help me to find these plastic clips i need on a 28b balance

I need the following sliding window channel balance - model 28 3 EX CMC 7. What part should I buy? Thanks!

need to replace original balances. 29 inches long and stamped 28B

Sirs: I would like some help in ordering 2(two) replacement balancer for my windows. Checking your page featuring window balancers, I think that item S380 - 2875 would fit the bill. Please advise. Thank for your attention Flavio

Hello can you give me a replacement part number

Unique 28-A-10 Non-Tilt Balance Replacement needed. Metal channel is 29 inches long. 9/16 inch wide (1/2 inch)

Good evening, I want to purchase new channel balance, I'm not sure which one is the right fit. I measured and it's 29". I attached pictures with some markings on my previous one. Thanks in advance.

I have a balance bar that needs to be replaced. It has a marking 28 9 of BSI on the bar. It measures !9inches long and 10/16wide. Can you help me get a few that matches what I have that is already assembled? Thank you, Ivonne

Hello, I have channel balances 29" long metal (not including plastic ends) I don't have window measurements, but I do have the screen measurements for that window: 31" tall and 49 1/2" wide. The only stamps in the channel metal that I can see are "28C USB". Please advise which channel balances ... (cont.)

29" metal part, can you help identify specific replacement? I have 3 windows with broken balances...need at least 6.

The channel length is 29" (Not including end caps), width is 9/16"...and channel depth is 1/2" This is a large window....roughly 50" wide. Markings are 28F. It appears to have a 19-023 top and a 15-077 bottom...but your "wings" look wider than mine. On mine...total width of end pieces at wings is 15 ... (cont.)