Viewing all customer Discussions for:

S380-29 29" Series 380 Channel Balance

Not sure about the number on the Balance,(needx4) it's a little worn away? Channel is 1/2" wide and 1/2" high as opposed to the regular 5/8" variety. I am maybe thinking that the springs are maybe a little on the high side owing to the cracked and bent top window shoes on two of the windows? I'm als ... (cont.)

Looking for replacement for UNIQUE 28-C-30 channel balance. It looks like your S380-29 2840 but the bottom shoe depth is 3/4". It has a 1/2" channel and the wings are 1" wide.

Hi, Could you please confirm the part number? this appears to be a 28" series 395 channel balance, but it measures 28.5". Stamp indicates 27 1/2" 3 Caldwell DM. Can you please confirm length and appropriate option?

Hi, if someone could review the attached photos and advise me as to the best replacement product you offer it would be greatly appreciated. I will need a pair for 1 window. Thanks !

Can you please help me identify this part I'm going to Pair it with a 29 inch series 380 channel balance

good morning Could you please help me to identify my window balance , I would like to buy about 10 of this to replace my windows . Thanks you very much and I wish you have a good day ahead Tuan

Please assist me in selecting the correct part. I need both left and right Chanel

Hi, I'm looking for help in identifying the right Top Sash Guide for my windows. Can you let me know which are compatabile with the channel balances I previously purchased (S380-29" Series 380 Channel Balance Option: 2860)? I attached a picture in case that helps. Thanks a ton!

29 inch long channel 9/16inch wide Stamped 28G Non-tilt window Sash weigh 39lbs

What part number should we order to replace these in our windows? Thank you for your help.

29"

I have a total of 14 windows that have rusted channel balances. I have included photos for one of the windows, but am including the other part numbers listed on the channel balance, their length and quantities needed. All windows are NUAIR and seem to be the same model family, just different sizes ... (cont.)

I have a few channel balances that have pulleys broken. I don't see pulley replacements on your site. If not, I'd need to replace the entire balances. Also the top guides are broken. I believe they are '5/8" Top Sash Guide, Kinco' in your site. I.e., dimensions seem about right. Can you assist? ... (cont.)

Hi. I have an older window sash, from a house built in 2005, that I need to replace. It's marked as 28F USB. It's a one-half inch channel with a length of 29 inches. The photos I uploaded show the broken sash next to a new one - one of your models, 2820. The new one is on top. Note that the spring i ... (cont.)

Need 2

We are trying to replace these springs on our windows .When we removed Sash the springs fell out we need help locating correct springs.

I need window balance channle. the stamp says 28C and 28D. On your website can't find the same stamp. Could you please tell me which one is compatible with 28C and 28D.

I think I ordered wrong (2840) it seems.These are 29 inch long and 1/2 inch wide and has 28-C stamped on them.From above would you please identify what part do I need.Shoe is about 3/4Thanks,Bharat

Good day! I could use four balancer parts. I look forward to your reply. the metal part of this is 29 inches.Bob

I need some channel balances for this unit. The windows are from Florida Extruders International They are the Milestone Single Hung Series 1000. The channel is 29" long and 1/2" wide. The spring is 14". The only marking is 28B. It seems similar to your S380 other than it does not have a ramp ... (cont.)