Viewing all customer Discussions for:

26-229 Right Hand Tilt Latch, 2-1/8"

This is the retractable tabs at top outer edge of window that holds window upright. You use these to release top of window and lean window in to clean outside of glass from inside the house.

Absolutely no markings on this latch or the window. I need to replace both sides.

What size screws do I use for the 26-228/26-229 window latches? Are the 33-072 screws long enough or do I need something else?

Hello, I have Boreal double-hung in tan/sand (not sure of real color name). The sliders used to open the latch have broken off. I am hoping there is a direct replacement. Thank you!

Upper latch for my window needs replacement. Only one. Can you identify part number

This is the latch I need spring hidden. Patten #4901475

I need to replace both the right- and left-hand tilt latches on an old vinyl window. Photos show what I'm working with. The dimensions of the 26-111 item seem to be a match. I've attached photos - does this look like a match to you? I will need the latch and the sash release levers. The 26-119 lev ... (cont.)

Thank you for any assistance also looking for window stops which would only allow lower windows to open for ventilation.

Hey, trying to find some parts for Dbl Hungs on a house I'm working on. I need shoes and coil spring help. I also need the pivot bars (26-226) and sash latches (26-110,111), but I already identified those on your site. On my old coil springs, I looked for a stamp on the two tapes that are connected ... (cont.)

How to remove and replace window latch.

Hi, I have these older double hung windows with latches that serve dual purpose of tilt lock and locking window in closed down position.

hello. need help to identify internal tilt latch set.

What is you item number to order

can you please help me find out this parts numbers so I can order them. Thank you!!!

I need this replacement part for Acan Window

Good afternoon. We have tried to no avail to find the correct size to fit our windows and then I saw your site. I am wondering if you can help us. I have attached 5 different photos so you could see the part we are looking for as well as the size. We have ordered from other sites but one part nev ... (cont.)

4 bottom guides straight (LIC PAT 5,069,001) 1 Sash top cover 1 bottom 90° guide 6 Sash locks internal with springs

The measurements of my tilt latch release match your product 26-234 with the exception of the distance from tip to tip of the "hooks" on the side view of the underside. My gap measurement is 3/16" -- same as yours. Each "hook" is 2/16" across (side view). So my total distance from tip to tip of t ... (cont.)

Hello I am looking for both left and right side tilt latches for some original gapco windows. This house that I am working on was built in 91. The latches appear to measure 3 3/16" long, 1 1/8" wide and 5/16" thick. With hole spacing 2 1/8" on center. Thanks for all the help.

Need two sets of the tilt brackets. Only markings are "Better Built" on locking mechanism. Please advise part numbers and cost. Thank you?