Viewing all customer Discussions for:

33-206 Shoulder Bolt Washer

I can get the window to open but I can not get it to close. The handle comes out of the operator.

Order : 1948474Hello,I am trying to replace window cranks that have a KD JAL marking. I live in the Northeast.I purchased Keller Window Cranks (39-061). As can be seen in my photo, the installation holes pattern is identical to my old original, but are offset to the left by approx. 3/16ths. It won't ... (cont.)

Good afternoon, I need to know which part # to buy for my jalousie window. I need the entire mechanism shown. Thank you,Zach

LEMCO SERIES 30Will you need photos of the inside of the current broken crank to determine what model I need to buy

I'm trying to find which series can replace the left awning window operator.

Hello - was hoping you could help with identifying a crank. The interior markings are: Pat. No. 198202 US 2 R.H. RD. 1963 CAN 93 Thanks for the help.

Dear SWISCO Customer Service: I bought and received a 39-025 Awning Window Crank Operator replacement from SWISCO. At the end of 2-3/8 tongue on the crank operator, you provide a shoulder type screw. The shoulder screw diameter is too big and I cannot insert to the existing hole at the window. ... (cont.)

I need a replacement for this window crank. Attached are the dimensions I frequently see on your descriptions

I need a jalousie window operator. Mine has this stamped inside:Pat. No. 19E 202 USAR.H. RD. 1963 CAIt has a dog-leg in the second linkage to clear part of the window mechanism. The second linkage is 2 5/8 inches center to center pin distance.Hope you have one? Bill

5 1/4" long hole to hole.... 3 5/8" center to center hole offset arm.... 1 1/8" wide mount holes center to center on bottom. 5/16" pin hole for E-clip.

Looking for replacement aperator

Hello, we are looking for this window operator. It's from 1965. Do you carry it? Thank you, Mark Messner-Chaney

I'm trying to replace this part. I purchase part number 39-278 And it doesn't work. The window locks about 1 inch from closing all the way. What is the correct part number that I should've purchased? Can I return the parts I already purchased? Do you also sell the round clips?

The mount on the crank housing broke and the worm gear that attaches to the handle came out. I jerry-rigged it and got it to close. Is a replacement available? I'll need a right and a left (so they match. Thanks.

Hello In dire need of a replacement crank operator. Picures attached but in case you cannot see, the words written on the shaft is L LEMCO CROFT METAL PRODUCT MCCOMB MISS PATENT NO [***I cannot read all of the numbers***] 28306?? 2852?? 64???

I have an awning casement window crank with a handle that separated from the operator. Please advise on the replacement part. Also advise on what hardware should be purchased for proper install. I currently have an e clip and 2 screws for the device, 1 was missing. The current part uses an e-clip t ... (cont.)

Unable to find replacements at any local stores. Can you help me out? Thank you. Gabe

I need nylon washers for jalousie windows approximately 1 and 5/8 in diameter.

All dimension are correct except the 3/8" hole where the crank attaches to the window. My dimension is 1/4". Is there a bushing, or something that will allow this crank to work, or is there another item that I need? Thank you for your help!

Hi. This is the type of Awning Window operator I need (this is a different window but the other is also "right side" and suffered from the same corrosion but broke)I am in Hawaii. Thanks!