Viewing all customer Discussions for:

15-150D 1/2" Coil Double Support

Hi- I purchased some 15-150Ds to replace a handful of coil covers that are breaking down but as you can see from the picture they're not quite the same. I installed one, and it works, but the sash doesn't slide past the cover without pulling in the retaining clips. It also seems a tad loose in the ... (cont.)

Hello, I am looking for the correct balance hardware for these MI Homemaker II windows that were manufactured in 2009. The window size is 29 1/2 x 53 3/4.

Good grief! First time window repair. Bought 1997 home and a lot of these are broken Can't find MFG info. Numbers barely visible on spring on bottom pivot: 6.5 33" T523203 ??? Smaller inner coil has a "3" on it. Upper unit attachment ends are missing. Marking on upper has ? 9 Thanks for any ... (cont.)

Hello, Need assistance identifying the correct replacement parts for a Simonton Double Hung 35.5 x 53.5 Contractor Series Window from 2005. I believe I have the correct Tilt Latches identified?#26-243 (LH) and #26-244 (RH) ? need 2 of each for top and bottom sash. I also believe I have the corre ... (cont.)

I have several windows that need replacement to keep the windows up. The pictures I am showing belong to my morning room. I do noticed that in my bigger windows upstairs, the top gadget is the same but the bottom pivot foot has three metal rings coming out it. So does it depend on the size of the w ... (cont.)

Hi There, I need coil balance (Sears) for 19 lB Sash, Is your S140-10 right one to use? Please see my photo attached. Thanks a lot!

Marking on one of two springs says 5.5#, 33". I need 6 of these to repair 3 windows. Including posts. Post is 3 inches long with hole at 2 inches. Thanks for helping me be sure what I need to order

Both springs are feed down one side to the shoe

Stamped on the cover: Part# 801020, Patent #'s 5.232.208, 5.365.638.6.584.644 B2 Coil is 1/2" wide, cover is 3" long and 1 1/4" wide Stamped on coil is #3.5 35" P First photo taken before I removed it from the window.

Dear Sir/Madam, Our window is hard to be left also will not stay at left position. After took the sash off and found springs on both side are damaged, each side has two pieces of springs. I can only find "MEGA 6.5 33""makings on one piece of the spring and can not found anything else. The sash siz ... (cont.)

i am trying to find this part for a window repair

The white plastic cover for the flat coil-based balance spring has weakened in the sun, causing it to crack, making it difficult to open and close the double hung window. It appears the shoes and the coils themselves are intact, though perhaps one of the coils is a little bent. The locks on the wind ... (cont.)

What balance do I need for this window? 0003281501 It's 2 spring and I think 3/8 spring width

To whom it may concern. I own and manage 24 rental properties in Baltimore. Some of the windows need replacement springs and I am wondering if, based on the attached photos, you could give me your best guess for what parts I need to order. The windows are 34x60 (which hopefully will help guess the c ... (cont.)

Referring to your email (copy enclosed - see email.jpg), this would be part #15-150D. I need one of these to fix my current problem window, but would like to order extras - 3 right side housings and 2 left hand housings. I have included a picture of the left hand housing in picture 4, showing the ... (cont.)

Looking for the double supports, shoes, 1/2 coil.

My window coil balance is broken. I just ordered two of the series 160 balances (7.5 lb for a 14.5 lb lower window). However, It appears that I have four of the coil balances two on each side. So with that in mind and seeing the pictures what coil springs do I need and do I need to replace other par ... (cont.)

I need these parts. Thanks.

Hoping to replace all 3 parts in all windows in my home

Simonton and Home Depot can't help. The windows are twenty years old andneed several parts. Hopefully you can identify them. Thank you for your help.