Viewing all customer Discussions for:

S380-29 29" Series 380 Channel Balance

Need replacement balancers for Florida Extruders Int. Single hung series 1000. 29" metal, stamping looks to be 28D.

I need help ti get the correct S series for my balancer. Is it S 380 or 385, or something else. Thanks,Ted

Stamp on side shows 28D, Frame is 9/16" wide, the metal frame is 29" long. I have ordered from you before. Your order number was 1347517. Those were S395-26 but these ends look different and they are longer. These are for our condo clubhouse windows.

The only markings I could find were those in the attached photo "2840". The window weighs 28lbs.

I need to replace the channel balance on a few of my windows and all it says on it is 28B. Can you tell me which one it is? Thank u

29 inches long from one end to the other end from the metal part only by 1/2

Hi. The pictures I have attached are for two windows. The length of the balance is 29 inches are there is a number stamped on the side. It is hard to read, but I believe it says 28C USB. I have ordered from you before and have had great success. Thank you so much!

Please help in choosing the right one. I need 6ThanksGeorgi

Measures 29" long and has marking which look like 28G (or C) and USB

Purchased S380-29" but can't fit my window in. Upon comparing it to the original channel (see images), I noticed that the ones I purchased are at least 2 milimeters deeper. How do I go about getting the correct one?

The part pictured has U B 28B stamped on it. I have a list of windows that I need to replace the balances in and they have the below stamped on them: 22B 28D 16A 28A 22D

Stamped number on balancer is 28D. It measures 29" long. I need a total of 12 new complete balancers for 6 windows. Windows are 16 yrs old, Label states it's a Milestone Horizon Roller Series 1000

Marked as "Unique 28-G-70

Need these replacements identified.

The stamp on the channel balance I have is UB 28D. Can you cross reference this to your numbers?

Hello, I have NuAir Non-Tilt Windows on which I need to replace the Channel Balances. Based on internet videos, I believe they are BSI 1/2 inch Channel Block and Tackle Balances, Non-Tilt. The numbers stamped on the Balances are d 2830. My photos are attached. Please determine the correct ones ne ... (cont.)

Please identify for me to install correct one Thanks

Hi SwisCo, Firstly, thank you for providing such expert videos and forum advice. I particularly found helpful your comments to a customer in Naples FL (https://www.swisco.com/discussions/Channel-Balancers-for-Milestone-Single-Hung-Series-1000-Windows-77-158971). Like the customer in Naples, I am ... (cont.)

The house is in Florida, 6 years old. Vinyl windows with impact glass. One balancer cord broke. Stamped on the metal is "28DS 37" The metal channel is 30" long, 9/16" wide. Can you help me idenify this?

i need replacement with this channel balance wich one should i order