Viewing all customer Discussions for:

S770-24 24" Series 770 Balance

Need a couple Balances.I need 2-24" channel balances that are 24" by 1/2" by1/2" I couldn't find them on the website. Thank you.

Metal part is 24" OAL. Window measures 26" high x 33" wide

This is an upper sash balance. Part number 5.737.877. The plastic part at the end of the rod is broken and does not stay in place.

Can you identify this part, or provide a substitute?

Hi This is out of a 1990-ish Harvey window. Length is 24" , 1/2" square body. Let me know if you have anything that might work?

Hello looking for the attached window balancers. Also need to replace a broken pivot bar. Thanks Rich

The balances are stamped 23S 28 and 24" long

No markings balance is 24" long

Quantity: 8 Length: 24" Stamp: 2340

Are these Series: 770 or 795? I need: 10qty SWISCO Series 24" Channel Balance Sash Support System. " ": 11qty window latches that holds window in upright postion. " ": 11qty window locks If you provide me w your email, I'll provide more pics.

I have double hung windows. The pane is 28 pounds. The existing channel balance is 24" long and is hooked on an opening below a screw hole (see picture 4). The screw hole is 1" above the opening, so do I get a 24" long replacement, or do I get a 25". Thanks

Hi, can you ad use as to the exact replacement part needed for the two channel block & tackle window balances? Thanks, darrin

Hi, The current channel balance makes a loud squealing sound when the window is moved up or down and lubrication on the balance helped for a few hours and then the noise returned. I think I need S770-24 inch, but not sure if I need B or C etc. The existing balance says "BSI 2400 J" and if I had ... (cont.)

Need 4 each of these

looking for these balances

I need 4 window balancers to fit Harvey window

2365 HT 24in length

Stamping on part is 23HD. Length: 24"; cross section is approximately 9/16" sq. The pictures show both ends of the removed balance that has a broken shoe and a picture of the other balance that is installed to show the full profile of the unbroken shoe.

Need 12 balancers i replaced some with the new ones you see ,need 12 more .

window balances have failed. Top has a z shaped hook formed from sheet metal that clips to top rivet on balance and uses final fold in metal to hold hook on the rivet. 22F and 24F stamped on metal.I don't know if there is a better solution to trying to find exact replacement parts. Here's what I fo ... (cont.)