Viewing all customer Discussions for:

S385-17 17" Series 385 Channel Balance

We ordered part S380-18 option 1710, S385-26 option 2510, and S600-25 red tip last week. When we install them, the windows cannot close and stay open about an inch. My field tech is telling me that they are all an inch too long. I do not have the original balances from the window. I need to re ... (cont.)

length of window balance is 17 inches width is 1/2 inchOnly number marking is 16E as seen in 1763 jpgDon't know the window make/manufacturerWould like to order 2 Need to replace because the string broke inside on one of the balances.Gary thanks

I have a window balance to replace. The metal portion is 27 inches long, not including the plastic ends. The stamp reads "26 4 GW CMC 7". It is for a Milgard, single hung, non-tilt window. The portion of the window that it lifts weighs 25 pounds. The actual dimensions of the window are: 3 ... (cont.)

I need to replace one broken window sash part. The set I have appears to be two different manufacturers. The broken one says Caldwell. Thank you.

Brad here again.This is from my bathroom window. Another Kinro window. Window V.O is 27 1/2" x 36 5/8". The channel length is 17". That's the metal channel length. There's a serial # visible in pic 2. I would like to replace both sides.Thanks!Brad

I'm looking for 2 sets of the attached pictures. The picture is of a good set of balances for my windows. The channel lengths are 16-3/8" and 17". Markings on the 17" one says 16 3 IN CALDWELL. Markings on the 16-3/8" one says 16 3 BSI DR

17" channel balance 1620 BST. Need 2 replacements - interior portion is broken. Thanks so much. Bud

I need a replacement for this channel balance. The width is 1/2" and the length is 17". The balance is printed with "16 2 IS CALDWELL". There are no other markings I could see. Thanks for your assistance!

I am looking for a replacement 17" sash balance with 1620 stamp.

I need two balances, 17" in length. The old balances are stamped with 1620. Pictures are attached

I need 2 of these balance bars.

Looking for the correct Swisco Series to replace BSI Balancers. The numbers on the balancer are "1610 BSI BX". Please see attached photos. Thank you.

if you can identify replacement balancer, I need two. Thanks

Hi,My sash has ink stamp "16-4 KX CMC 9"Please advise me as to the correct replacement in your catalog.I appreciate your help.Please stay safe in these troubling times,Regards,Joe

Hi- I have attached photos of a window balancer from a window in a condo located in Florida. The building was built in 1984. I am looking for new balances. One of the photos includes a stamped number on the channel. Jim

We need 2 of the side load balances. Measurements are: 16-3/4" Long 1/2" wide 5/8" deep on each side. #1620 DSL

I think this is Apex Extended block and tackle balance. Do you carry a replacement?

I need to replace a broken balance. I think it is a channel balance, 800 series. What do I need to buy? Thank you.

This measures 17" long I would like to order two of these

Hi ? I need to order a couple replacement window balance channels from you but am unsure of the proper part number. They are 17" long (measurement of metal only) and are stamped "16 3 IR Caldwell" Thanks for your help, ~ Grant