Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

Not counting the connectors, the metal body is 30 inchese

I need replacement load balancers. The stamp is 29C USB.

Looking to replace all of mine. Need to identify so I can order If you need any further information please let me know.

This is the original Chanel balance. Can You match this with a product number in your stock?

I need to replace the pgt spring balancers. Balancer is 30" in length. 9/16" wide

Per the label on the window these are ALC-1 Alcan windows. Both channels do not stay in place. They tend to drop down. The one channel has a broken string. I'd like to get two new channels. The code on the channels is 2920-0. The channels measure exactly 31 inches including the plastic clips on each ... (cont.)

2930 B.S.I. BALANCE IS 30 INCHES NOT COUNTING THE PLASTIC CLIPS

I need 8 pairs of these balance. The part number is showing in the picture. They show different numbers, but they all actually look the same to me. The two plastic ends look the same. Can you help me to identify which part I need to buy? Thanks a lot!

Window brand. Norandex. Clips have broken on all windows allowing balancers to pop up on side track of windows. I am not referring to clips attached to balancers. Do I need to replace balancers that appear to be fine and just reinstall with new clips as shown in photo?

You can see the front and back of each end of the plastic clips. The number etched into the track is 2910. Measuring it metal track end to metal track end it is 30" I have some tracks in my checkout cart already....I THINK I have the correct ones but I'd rather you tell me which track I should order ... (cont.)

I was hesitant to order 4 of Product Code: S385-30 on-line because the bottom fitting seems to be a little different. I don't think it will make much difference but wanted to check and make sure.ThanksRick

I need to replace the channel balances that are stamped 29 5 BSI. What weight category do I need? Thanks

I don't know which sash guide is a good match? I also need a couple balance springs too. They are 30 ". From metal end to metal end. The plastic ends are not included in the length.

The part is 30" metal to metal, 1/2" wide. Non tilt window. Any help would be appreciated. Plan on buying 12 pieces and want to make sure I order the correct ones.

Do you know which one I will need to order based on the attached pictures? Thanks for your help!

I am looking to order 6 of the 30" 29-9 channel balancers with the plastic ends as shown in the photo. I am having trouble finding them on your site. Please let me know if you need any additional photos or info. Thank you!

I would like some help identifying the correct channel balance and sash guide for my window. I have non-tilt windows, the channel balance is 1/2" wide and 30" long, and is stamped 2930. I believe the sash guide I need is 18-161. It is 1 3/4" long, and the other measurements seem to match those lis ... (cont.)

The rod is 30 long and 9/16 wide. Both sides are broken. I looked on your site and cannot figure out which 30" series is right.

29 9 ET CMC 2 is on channel.

I have part # 3530 BSI 36"; 2920 BSI 30"; 1030 BSI 11"; 2630 BSI 27";