Viewing all customer Discussions for:

15-129 Pivot Shoe, 9/16" Thick

This is the photo of the part I need to replace: The centre finger of the 3-finger vinyl piece on the opposite side of the window has broken off. The release clips that allow the window to slide up and down are labeled "Boreal". The functioning trident piece (in the photo) is stuck at its high ... (cont.)

I have Crystal replacement windows in a property I own and I would like to return them to working order. The attached ZIP file contains pictures of the parts I require. After looking on your website I came up with part number S600-14 white tip, S600-16 white tip and 15-120 for the pivot shoe. I c ... (cont.)

Vinyl tilt windows 36x62. I need the pivot feet also. I need a set of two...one for each side of the window.

I need to replace this, but no one locally has it.

Hi, my home has a single hang window and the channel balance and pivot shoe has broken so I can't open the window. The manufacture is Pollard windows and doors.Please see the attached photos of the actual size of the parts.Could anyone help me find the right parts to fix the window?I really apprecia ... (cont.)

I am requesting assistance in identifying replacement parts (channel balance, pivot block, and pivot bar) for a double-hung window. The window was made by "Timeline Vinyl Products" (which is now out of business) and was installed in 1997. The lower sash of the window measures 37.25? wide x 29? tal ... (cont.)

Shelter double hung windows This part allows windows to be removed and locks the balance in pkace

Please help identify the "sash lift" that is needed for this vinyl replacement tilt out window.

The window sash hooks into the stop and the stop is attached to the channel balance. No numbers are on part. Slides in a track on vinyl window.

Hardware is twenty some years old. Is there any chance of replacing these with coils? The channel is 9/16" X 1 .1/4.

Windows installed new 2003. No identifying marks. If you need more photos let me know. Sorry photos uploaded side ways!If have parts, I have

When put in tilt-in position, window falls out. The pictured devices on the sides of the frames , containing pulley strings, are at different heights now. Don't know how this happened. Not sure which parts are at fault. Hope window does not need to be replaced.

From the pictures, it appears 15-129 pivot shoe is correct, but to verify, mine is 9/16 thick x 15/16 wide x a bit over 1/3/4 long (top is broken off) Also the 26-310 pivot bar looks correct. These two parts are compatible? Thanks.

Do you have a replacement part?

Hi Can you help me to identify the replacement shoe? Will it be 15-188 or 15-135 or other? The size is 2"x 1/2" and 1 1/4". See the attached picture

windows were installed in 2009 face of pivot lock measures 1 1/4 inch. depth is 5/8 inch. Height is 2 1/8 inch.top metal plate that holds the spiral balance is not in this pivot lock. Could you tell me which pivot lock I need as I have to replace all windows. Thank You Stan McIlvee ... (cont.)

There is a metal spiral piece inside of a plastic sleeve about 1/2 inch in diameter. The part that attaches it to the window frame is plastic, too. It is almost 30 inches long.

I purchased Pivot Shoe, 9/16" Thick 15-129. However now the window will not shut enough to lock. Is there a shorter shoe you would recommend?

Looking to replace channel balance Length- 28 inches (metal frame only) I believe it's type 770. Markings are -0B. ???? DB 27-7. Also looking to replace the pivot shoe that is demolished ( photo attached) There is no cutaway to remove, so any suggestions on correct part and replacement process is ... (cont.)

Balance is 35 inches long the window block is separate and connected by a string with a metal collet.